You are not logged in to Prodigits. Please register or login.

Subject: Heatpro0f tape
Replies: 8 Views: 1420

john.doe 6.12.09 - 04:03pm
Wat can i use dats heatpro0f/firepro0f can i use 2 tape a hole up in a pipe in engine * +

recurv09 6.12.09 - 06:31pm
Wot pipe is it ? * +

d4dawg 6.12.09 - 09:45pm
As above wat pipe? Rubber water hose/metal braided ? As rubber u could patch up with bicycle puncture kit I guess, if air or water under low pressure, if nor easier to replace, if metal, u could use exhaust repair tape, heat resistant toi * +

john.doe 6.12.09 - 10:51pm
Fink its an airhose pipe its metal * +

d4dawg 6.12.09 - 11:16pm
Intake pipe? As in straight from front of car to throttle body/ air box? As if that, and no sensors before it, then a simple patch or slit and glue to it, a piece of new slightly larger but tight fitting pipe, but make air tight, but if from airbox to throttle body n has sensors in that section, get a replacement as will interfere with air/fuel mix * +

recurv09 7.12.09 - 04:43am
If its just an air intake gaffer tape would do if used properly, or chemical metal (putty) would be more resiliant, but if unsure just play safe and replace pipe... * +

d4dawg 8.12.09 - 12:16am
Hmmm depends upon how big a crack, as can get radweld, which u put in coolant n will block small holes, thing is if coolant is present at gap, it'll be hard to fix as water present , but as above, u can get a metal paste, when mixed turns solid, or use silicon sealant if only v temp * +

d4dawg 9.12.09 - 08:32am
Not good, go to a scr*pi n see if can get 2nd hand one? * +

+ go to page 1-2
+ my page
+ functions
3 search
4 submit a reply
7 last page
+ bookmark
8 Cars&Motor Sports Forum
9 Forum Index

Custom Search